MATERIALS PREPARATION CENTER
<<BACK		Profilometer Hommel T-8000 surface profilometer (right) and Falex ISC 450 pin-on-disk tribometer (left). Profilometer •T-8000 diamond tip contact surface profilometer. •Can measure 2-D or integrated 3-D surface traces. •Practical measurement of features from 0.2µm to 1.2mm. •Measurement area up to 5cm x 5cm with a minimum parallel trace distance of 2.5µm. •Computer control and data acquisition Software for interpreting 2-D and 3-D measurements. Tribometer •Falex ISC 450 pin-on-disk tribometer. •Normal loads from .01 N to 10N •Rotational speed from 30-300 r.p.m. •Wear scar diameter 5mm-50mm •Pin holders for most ball materials 1.5mm - 6.35mm •Controlled humidity testing •Temperature control from 25oC to 600oC •Computer control and data acquisition
		Ames Laboratory is a U.S. Department of Energy Laboratory operated by Iowa State University under Contract DE-AC02-07CH11358, and is a member of ISU's Institute for Physical Research and Technology. 2006 © Ames Laboratory All Rights Reserved Privacy & Security Notice Disclaimer & Copyright Status Search MPC Home | General Information | Contacts | Accessing MPC | Equipment | Services | Publications | Ames Laboratory